![]() |
Starting a new topic? Please try and put it in a relevant forum (Riding, Building, etc) but if you're not sure it's better to post in any forum than not to post at all. |
Carbon wheel disks and moulds |
Post Reply ![]() |
Author | |
bazz ![]() BHPC Member ![]() ![]() Joined: 29 December 2009 Location: West London Status: Offline Points: 301 |
![]() ![]() ![]() ![]() ![]() Posted: 13 August 2011 at 6:17pm |
How Do All ;-)
I have a pair of home made Carbon wheel disks which I no longer require and have no room for; along with some home made moulds for them, maybe of interest to anyone wanting to try disking their rear wheel or maybe have a go at making some disks,
The disks are held to the rim with small rubber bands over Carbon clips, and a few zip ties at the hub.
![]() there is also a split gauge which I used to measure the dishing should you want to make some more moulds.
The carbon disks are for a 26" wheel with disk brake hub, the disks can be spit and re-joined if needed to correct the dish to a particular wheel, as I did on the drive side.
The finished moulds would benefit from a little filler along the join line as there is a small ridge I was not too fussy about that though.
please see the pictures in this album for details.
If anyone would like to slip me £20 for the above, I can arrange to bring the lot to Hillingdon.
Take care,
Barry ;-)
Edited by bazz - 13 August 2011 at 6:21pm |
|
![]() |
|
bazz ![]() BHPC Member ![]() ![]() Joined: 29 December 2009 Location: West London Status: Offline Points: 301 |
![]() ![]() ![]() ![]() ![]() |
Now Taken; Pending collection.
Thank you,
Barry ;-)
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |